Guitar hero world tour guitar fix windows#

Check to see if the guitar button in question is functioning in the Windows control panel.Click the Advanced button aqnd make sure your controller is listed as the Preferred device.Click on the properties button, calibrate and test the controller as needed.Click on the Start button, then the Control Panel.Click the Advanced button and make sure your controller is listed as the Preferred device.Click on the Properties button, calibrate, and test the controller as needed.Double click on the game controllers icon.Click on the Start button, then Setting, then Control Panel.To check your controller in the Windows Control Panel, choose your operating system from the instructions below: Make sure that the controller is recognized and active in the Windows control panel.Look for the red indicator light above the strum bar. First verify that the guitar is connected to the PC.

Guitar hero world tour guitar fix Pc#

If your guitar controller is connected to a PC version of Guitar Hero: Being too close or too far from the console may interfere with the wireless signal.

Vary the distance between you and the console.

Remove large metal objects near the wireless transmitter that can interfere with the signal.

If your console is inside an entertainment center, please remove it and try to sync the guitar again.

This includes cordless phones and other wireless controllers.

Move or turn off anything near your console that uses a wireless transmitter.

If you need help syncing your guitar, check out question one of this FAQ.

Restart your console and re-sync your guitar.

If your guitar controller will not function, first try the following steps:

Insert the Wii remote into the controller compartment.

Plug the connector that is inside the controller compartment into the bottom of the Wii remote.

Sync your Wii remote to your Wii console.

Then the four lights should stop flashing on the guitar and only one will remain illuminated.

All four lights should flash on the guitar and the Xbox 360 console.

Hit the sync button (the button next to the USB ports) on the console.

When you do this the lights on the guitar around the Xbox 360 guide button should chase themselves in a circle. This is located next to the headset connector on the bottom of the guitar near the strap peg.

Press the sync button on the bottom of the guitar.

If it is taking longer than a few seconds and the lights are still flashing press the PS button again, you may need to hit the PS button several times.

The red lights above the strum bar will stop flashing and only one red light will remain illuminated. If there is a solid light displayed on both you are ready for the next step. Press the small button on the front of the dongle if there is no light or the light is flashing.

Check your guitar and dongle for a red indicator light.

Connect the wireless dongle to one of the USB ports on the front of your PlayStation 3 system.

I am sure thin rubber insulation, felt, craft carpeting.etc will work as well.In order to connect your Guitar Hero controller to your console, choose your console from the following list and follow the instructions: I just used it becasue it had industrial stick 'em on it and it won't just fall off, I knew it would mat itself down after a while, and it looked a decent thickness.

Guitar hero world tour guitar fix mod#

This will strum the note without having to press the strum bar all the way down ( more like about 75% of the way down) really good mod to use for expert adn alt strumming songs.Ĭan use otehr stuff instead of velcro. SIDE mod -while you still have it apart, you can cut similar pieces and put them on the rear of the strummer OR over the push in part of the strummer button onthe board. not the hard plactic part) and cut it aboutt he size of the rubber pads and stick them where the pads came from.Īt firts it will seem ike the guitar isn't getting to the peak of the strum but that will work it's way out in a few songs. Take a section of velcro tape ( the softer part. You'll see rubber stoppers on the strummer. Unscrew the strummer holders and remove them Unscrew the board behind the strummer and lay it off to the side.

Just open up the guitar (careful not to put weight ont eh whammy as it will pop out of the bracket holding it inplace) This works on any of the guitars and take about 5 minutes to do. The strummer is an easy fix if you want to mod it to be quieter.